Please remember this is Printable Transfer Vinyl …
Also please don’t forget to order the heat masking tape on our website! You will need this to go over your design to properly place on your shirt to press..
Application Steps (Home iron):
1. Remove any extra packaging vinyl that may be stuck to your heat transfer to protect it during shipping.
2. Set iron dial between cotton and linen.
3. (Optional) Cover design with Kraft paper or non-stick cover sheet.
4. Place on flat, hard surface.
5. Press iron with firm pressure on heat transfer.
6. Press each section of design for 15 seconds or longer if needed.
7. Slowly peel off the clear carrier. (You should see the texture of the fabric through your vinyl after you peel off the carrier.)
8. If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds as needed.
*Application Steps (Heat Press):
1. Preheat garment for 2-3 seconds
Apply design at 305°F / 150°C
2.Use firm pressure for 15 seconds.
3.Peel carrier hot or cold. If areas of the design are lifting repress until design has adhered to the garment.
Easyweed Vinyl Applies to: 100% Cotton, Poly/Cotton Blends, 100% Polyester, Leather.
THIS WILL NOT STICK IF FABRIC SOFTENER HAS BEEN APPLIED TO THE FABRIC.
*Washing instructions:
Wash on cold with garment inside out. Use mild detergent. Never bleach. Hang to dry.
Sizes of Prints:
Infant & Toddlers - 10in. wide-
Youth XS- Adult Xl- 12in. wide
2X through 3X - 13in. wide
4X & 5X - 15 in.